Dolmar AH1851 Manual De Instrucciones página 14

OPERATION
WARNING:
Keep hands away from shear
blades.
CAUTION:
Avoid operating the tool in very
hot weather as much as practicable. When operat-
ing the tool, be careful of your physical condition.
CAUTION:
Be careful not to accidentally
contact a metal fence or other hard objects while
trimming.
CAUTION:
Be careful not to allow the shear
blades to contact the ground.
CAUTION:
Overreaching with a hedge trim-
mer, particularly from a ladder, is extremely
dangerous.
NOTICE:
Do not attempt to cut branches thicker
than 10 mm in diameter with the tool.
Fig.24: (1) Cutting height (2) 10 cm
NOTICE:
Do not cut down dead trees or similar
hard objects.
NOTICE:
Do not trim the grass or weeds while
using the shear blades.
and pull the switch trigger while pressing the lock-off
lever, and then move it forward.
Fig.25
speed rate of 3 to 4 seconds per meter.
Fig.26
height and trim along it.
Fig.27
gathers discarded leaves and makes clean-up after-
ward much easier.
Fig.28
Fig.29
Fig.30
MAINTENANCE
CAUTION:
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
Cleaning the tool
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Shear blade maintenance
Before the operation or once per hour during operation,
Fig.31
Fig.32
NOTICE:
Do not wash the shear blades in water.
NOTICE:
Dirt and corrosion cause excessive
blade friction and shorten the operating time per
battery charge.
Storage
ing the tool from a nail or screw on the wall.
are not exposed. Store the tool out of the reach of children.
Store the tool in a place not exposed to moisture or rain.
Fig.33: 1.
Grinding the shear blades
NOTICE:
If the shear blades have considerably
deformed by grinding, replace the shear blades
with new ones.
-
1.
2.
Fig.34
3.
from the tool.
4.
catcher.
Fig.35: 1. Screw 2. Branch catcher
14 ENGLISH
Always be sure that the tool is
-
-
-