Dolmar AH1851 Manual De Instrucciones página 13

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When replacing the shear blades,
always wear gloves so that your hands do not
directly contact the blades.
NOTICE:
When replacing the shear blades, do
not wipe off grease from the gear and crank.
Installing or removing the shear blades
CAUTION:
Attach the blade cover before
removing or installing the shear blades.
You can install 500 mm, 600 mm, or 750 mm shear
1.
screws.
Fig.8: 1. Screw
2. Remove the cover and the plate.
Fig.9: 1. Cover 2.
NOTE:
3. Remove the rod.
Fig.10: 1. Rod
NOTE:
4. Remove 2 screws, the felt pad, the washers, and
Fig.11: 1. Felt pad 2. Screw 3. Washer 4. Sleeve
5.
5.
6.
7.
the alignment line.
Fig.12: 1. 2.
8.
at the same position.
Fig.13: 1.
9.
Fig.14: 1. Felt pad
10.
hole on the rod, then align the position of the felt pad
with the holes on the tool, and then attach new sleeves
and washers.
Fig.15: 1.
5. Sleeve
NOTICE:
Apply a small amount of grease to the
inner periphery of the hole of the rod.
NOTICE:
Be careful not to lose the washers and
the sleeves.
11.
Fig.16: 1. Screw 2.
2. 3. Felt pad 4. Washer
12.
Fig.17: 1. Rod 2. Small hole
NOTICE:
Apply a small amount of grease to the
inner periphery of the small hole of the rod.
NOTICE:
Make sure that the protrusion on the
13.
Fig.18: 1.
NOTICE:
Make sure that the protrusion on the
14.
Fig.19: 1. Cover 2. Screw
NOTICE:
Be sure to attach 2 long screws to the
center holes.
NOTICE:
If the shear blades do not move
smoothly, the shear blades are not engaged with
the rods properly. Install the shear blades again.
NOTICE:
If the parts other than the shear blades
such as the rods are worn out, ask Makita/Dolmar
Authorized Service Centers for parts replacement
or repairs.
Installing or removing the chip receiver
Optional accessory
CAUTION:
When installing or removing the
chip receiver, always wear gloves so that your
hands do not directly contact the shear blades.
NOTICE:
The blade cover cannot be installed if
the chip receiver is installed on the tool. Before
carrying or storing the tool, uninstall the chip
receiver, and then install the blade cover to avoid
blade exposure.
NOTICE:
Be sure to remove the blade cover
before installing the chip receiver.
The chip receiver gathers discarded leaves and makes
either side of the tool.
To install the chip receiver, align the hooks of the chip
Fig.20: 1.
Fig.21: 1.
NOTICE:
Make sure that the chip receiver does
not overlap the branch catcher.
Fig.22: 1. Branch catcher
sides to release the hooks.
Fig.23: 1. Lever
NOTICE:
Never try to remove the chip receiver
by an excessive force with its hooks locked in the
grooves of the shear blades.
13 ENGLISH
2.
2.