Lincoln Electric Saf-Fro DIGISTEEL 255C Manual De Instrucciones página 23

User Setup
To access the User Setup:

Press the Button [37] or Right Knob [36] to get
access of Welding Parameters Bar.

Use the Right Knob [36] to highlight the icon
"Settings".

Press the Right Knob [36] to confirm the selection.
Figure 13.
The User Setting Menu enables to add the additional
function and / or parameters to the Welding Parameters
Bar [44]:
Table 9.
Symbol Description
Preflow
Postflow
Burnback Time
Spot Welding
Run-In WFS
Start Procedure
Crater Procedure
A/B Procedure
Load memory
Save memory
USB Memory
WARNING
To change the Parameters or Functions Value, theirs
icons had to be added to the Welding Parameters Bar
[44].
English
To add the Parameter or Function to the Welding
Parameters Bar [44]:

Access to the User Setup (see the Figure 13).

Use the Right Knob [36] to highlight the parameter or
function icon which will be added to the Welding
Parameters Bar [44], for example Run-in WFS.

Press the Right Knob [36] to confirm the selection.
Run-in WFS icon will drop.
To remove the icon - press the Right Knob [36] once
again.
To exit the User Setup Menu – press the Left Button
[35].

The Selected parameters or function is added to the
Welding Parameters Bar [44].
19
Figure 14.
Figure 15.
WARNING
Figure 16.
English