Publicidad
Idiomas disponibles
Idiomas disponibles
Restore Factory Settings
Note:
After Factory Settings restore, the
settings stored in user memory are deleted.
To restore Factory Settings:
Access to the Settings and Configuration Menu.
Use the Right Knob [36] to highlight the Restore
Factory Settings icon.
Figure 58.
Press the Right Knob [36]. The Restore Factory
Settings Menu is shown on the display.
Use the Right Knob [36] to highlight the Check Mark.
Figure 59.
Confirm the select – press the Right Button [36]. The
factory settings are restored.
Diagnostic Information
Available information:
Software Version
Hardware Version
Welding Software
Ethernet IP Address
Power Source Protocol
Event Logs
Fatal Logs.
English
Advanced setup
This
menu
configuration parameters of the device.
To set the configuration parameters:
Access to the Settings and Configuration Menu.
Use
the
Right
"configuration menu" icon.
Press the Right Knob [36]. The Configuration Menu
is shown on the display.
Use the Right Knob [36] to highlight the Parameter
Number which will be changed, for example P.1 -
allows
change
"Metric" = m/min.
Press the Right Knob [36].
Use the Right Knob [36] to highlight the "English" =
in/min.
Confirm the select – press the Right Button [36].
29
enables
access
Knob
[36]
to
highlight
Figure 60.
WFS
units,
factory
Figure 61.
Figure 62.
to
the
the
default:
English
Publicidad
