Lincoln Electric Saf-Fro DIGISTEEL 255C Manual De Instrucciones página 27

Load – restore the data from the USB Device
to the machine memory.
To load the data from USB Memory:

Connect the USB to welding machine.

Add USB icon to the Welding parameters bar [44].

Use the Right Knob [36] to highlight the icon "USB".
Figure 29.

Press the Right Knob [36] to confirm the selection –
the USB menu is shown on the display.

Use the Right Knob [36] to highlight the icon "Load".
Figure 30.

Press the Right Knob [36] to get access of Load
option – the load menu is shown on the display.

Select the file name with the data to be loaded into
interface. Highlight the file icon – use the Right Knob
[36].
Figure 31.
English

Press the Right Button [36] to confirm the file
selection.

The display shows the Load Data Menu from a USB
Memory Stick to User Interface.

Use the Right Knob [36] to highlight the data icon
which will be loaded.

Press the Right Knob [36] to confirm the data
selection.

To confirm and load the data from a USB Memory
Stick, highlight the Check Mark icon and then press
the Right Knob [36].

To exit the USB Menu – press the Left Button [37] or
disconnect the USB Memory Stick from the USB
receptacle.
23
Figure 32.
Figure 33.
Figure 34.
English