Publicidad
Idiomas disponibles
Idiomas disponibles
ErL Error Screen
Pellet Error Screen
Igniter Error Screen
Auger Error Screen
Fan Error Screen
WWW.PITBOSS-GRILLS.COM
Grill fails to perform start-up
Check proper positioning of cooking components. Check hopper for sufficient fuel or if
cycle
there is an obstruction in the feed system. Remove pellets and follow Care and Maintenance
instructions. Check grill probe. Confirm if actual temperature is correct and accurate. Follow
Grill will not stay lit
Care and Maintenance instructions if dirty. Check Igniter positioning and that it is heating up
properly. In extreme cold, the grill may require a second start. Turn grill off, wait, then turn
Auger Not Primed
on again. Check fan. Ensure it is working properly. Follow Care and Maintenance instructions
if dirty.
Lack Of Fuel, Poor Fuel Quality
Check hopper to check that fuel level is sufficient and replenish if low. Should the quality
of Hardwood pellets be poor, or the length of the pellets too long, this may cause
an obstruction in the feed system. Remove pellets and follow Care and Maintenance
instructions.
Igniter is not working properly,
Unplug the unit to power down the unit. Plug in the unit and press and hold the power
not making a connection
button for three seconds to start up the unit. If not operating properly, call Customer Care
for assistance or a replacement part.
Igniter failure
Igniter needs to be replaced. Contact Customer Care for replacement part.
Auger motor is jammed, not
Unplug the unit to power down the unit. Plug in the unit and press and hold the power
making connection
button for three seconds to start up the unit. If not operating properly, call Customer Care
for assistance or a replacement part.
Fan is not working properly, not
Check fan. Ensure it is working properly and air intake is not blocked. Remove access panel
making a connection
(see Electric Wire Diagram for diagram), and check for any damage to the fan wires. Follow
Care and Maintenance instructions if fan blades are dirty.
Unplug the unit to power down the unit. Plug in the unit and press and hold the power
button for three seconds to start up the unit. If not operating properly, call Customer Care
for assistance or a replacement part.
19
PIT BOSS® GRILLS
Publicidad
