Publicidad
Idiomas disponibles
Idiomas disponibles
◾
Push and Pull – The reaction force
is always opposite to the direction
the chain is moving where wood
contact is made. Thus, the operator
must be ready to control the PULL
when cutting on the bottom edge of
the bar, and the PUSH when cutting
along the top edge (Fig. 7).
◾
Avoid unintentional contact
with the stationary saw chain or
guide bar rails. These can be very
sharp. Always wear gloves and long
pants or chaps when handling the
chain saw, saw chain, or guide bar.
◾
Never operate a chain saw
that is damaged or improperly
adjusted or that is not
completely and securely
assembled. Be sure that the saw
chain stops moving when the trigger
switch is released.
◾
When bucking, secure the work
piece prior to cutting. When
felling or pruning, identify and
secure hazardous branches.
◾
Aggressive or abusive cutting
or misuse of the chain saw can
cause premature bar, chain,
and/or sprocket wear, as well as
a broken chain or bar, leading to
kickback, chain throw or the ejection of material.
◾
Never use the guide bar as a lever. A bent guide bar can cause premature bar,
chain, and/or sprocket wear, as well as a broken chain or bar, leading to kickback,
chain throw or the ejection of material.
◾
Cut only one workpiece at a time.
56-VOLT CORDLESS COMMERCIAL 20" CHAIN SAW — CSX5000/CSX5000-FC
6
Linear kickback
7
Pull
Push
Pinch
15
Publicidad
