Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE:
When looping the saw chain
onto the guide bar, make sure that after
mounting the guide bar onto the saw,
the cutter orientation matches the cutter
icon and rotation direction arrow on the
housing of the saw (Fig. 11b). If they face
in opposite directions, reassemble the
saw chain onto the guide bar with the
cutters facing the same direction.
8. Reinstall the side cover onto the
chain saw housing and fully tighten
both lock nuts.
NOTE: Tension the chain by following
instructions in the chapter "ADJUSTING
THE CHAIN TENSION" in the next section.
9. Rotate the chain by hand to check
whether the chain is properly
assembled without binding.
Otherwise, reassemble the chain
and bar.
ADJUSTING THE CHAIN TENSION
1. Stop the motor and remove the
battery pack before adjusting the
chain tension.
2. Use the flat end of the included
multi-wrench to turn the chain-
tensioning bolt clockwise or
counterclockwise to adjust chain
tension according to the marks on
the side cover around the chain-
tensioning bolt (Fig. 12a) until the chain seats snugly against the guide bar with
the drive links in the guide bar groove.
26
56-VOLT CORDLESS COMMERCIAL 20" CHAIN SAW — CSX5000/CSX5000-FC
11b
11c
Guide Bar
Drive Sprocket
12a
Chain-tensioning Bolt
Rotation
Direction Arrow
Saw Chain
Side
Cover
Lock Nuts
Publicidad
