Publicidad
Idiomas disponibles
Idiomas disponibles
4. Turn the chain-tensioning bolt
counterclockwise with the flat end
of the included multi-wrench to
loosen the chain (Fig. 31b).
5. Remove the worn bar and chain
from the mounting surface.
NOTICE:
This is a good time to inspect
the drive sprocket for excessive wear or
damage.
6. Install new guide bar and saw chain, following the chapter "ASSEMBLING THE
GUIDE BAR AND CHAIN" in "ASSEMBLY" section.
CAUTION:
"ADJUSTING THE CHAIN TENSION" in "ASSEMBLY" section before using.
CHAIN MAINTENANCE
WARNING:
sharp and may contain burrs.
Only use low-kickback chains on this saw. This fast-cutting chain will provide kickback
reduction when properly maintained.
A properly sharpened saw chain cuts through wood effortlessly, even with very little
pressure. Never use a dull or damaged saw chain. A dull saw chain cutter leads to
increased physical strain, increased vibration load, unsatisfactory cutting results and
increased wear.
For smooth and fast cutting, the saw chain needs to be maintained properly. The chain
requires sharpening when the wood chips are small and powdery, the chain must be
forced through the wood during cutting, or the chain cuts to one side. During maintenance
of your saw chain, consider the following:
◾
Improper filing angle of the side plate can increase the risk of a severe kickback.
◾
Raker (depth gauge) clearance. Too low increases the potential for kickback. Not
low enough decreases cutting ability.
◾
If cutter teeth have hit hard objects, such as nails and stones, or have been
abraded by mud or sand on the wood, have the chain sharpened by a qualified
service technician.
44
56-VOLT CORDLESS COMMERCIAL 20" CHAIN SAW — CSX5000/CSX5000-FC
The saw chain must be properly tensioned following the section
Always wear gloves when handling the saw chain. The chain is
31b
Chain-tensioning Bolt
Loosen
Publicidad
