Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Chain saw
unexpectedly
stops running
during
operation.
Motor runs, but
chain does not
rotate.
Chain brake
does not
engage.
50
56-VOLT CORDLESS COMMERCIAL 20" CHAIN SAW — CSX5000/CSX5000-FC
CAUSE
◾
The chain saw is
overloaded.
◾
If the high-
temperature indicator
appears on the LCD
screen, the battery
pack or chain saw is
too hot.
◾
Saw chain is bound
in the wood.
◾
If the chain brake
icon
is flashing
on the LCD screen,
the saw is stopped by
the omni-directional
chain brake system.
◾
Chain does not
engage drive
sprocket.
◾
Debris preventing
full movement of the
chain kickback brake
paddle.
◾
Possible chain brake
malfunction.
SOLUTION
◾
Decrease the load.
◾
Allow the battery pack or chain saw
to cool until the temperature drops
to the recommended operating
temperature range.
◾
Release the trigger switch; remove
the saw chain and guide bar from the
wood, then restart the chain saw.
◾
Release the trigger switch; remove
the saw chain and guide bar from the
wood, then restart the chain saw.
◾
Remove the battery pack and reinstall
the chain, making sure that the drive
links on the chain are fully seated on
the sprocket.
◾
Clean debris from external chain
brake mechanism.
◾
Contact EGO Customer Service for
repair.
Publicidad
