Publicidad
Idiomas disponibles
Idiomas disponibles
To remove battery pack (Fig. 15)
WARNING:
location of your feet and children or pets
around you when pressing the battery
release button. Serious injury could result
if the battery pack falls. NEVER remove
the battery pack at a high location.
1. Hold the battery pack in the palm of
your hand.
2. Press the battery release button with your thumb and the battery pack will
disengage from the latch.
3. Grasp the battery pack and remove it from the chain saw.
WARNING:
and keep hands clear of the lock-off button and trigger switch when carrying or
transporting the chain saw.
STARTING/STOPPING THE CHAIN SAW
Before Starting the Chain Saw:
1. Remove the battery pack.
2. Make sure that the chain is properly mounted and the chain is correctly tensioned
according to the chapter "ADJUSTING THE CHAIN TENSION" earlier in this
manual.
3. Check the side cover to ensure that it is tightly against the guide bar and saw
chain without any looseness and damage.
4. Check the oil level and fill the oil tank as needed. Make sure the chain is well
lubricated.
5. Check the sharpness of the cutting teeth of the saw chain.
6. Make sure that the chain-kickback brake paddle can move back and forth easily
between the brake position and the operating position.
7. Hold the chain saw with both hands: with the right hand on the rear handle and
the left hand on the front handle.
30
56-VOLT CORDLESS COMMERCIAL 20" CHAIN SAW — CSX5000/CSX5000-FC
Always be aware of the
To avoid serious personal injury, always remove the battery pack
15
Publicidad
