Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Chain saw does
not cut properly.
Chain becomes
loose or drops
off the guide bar
during normal
use.
56-VOLT CORDLESS COMMERCIAL 20" CHAIN SAW — CSX5000/CSX5000-FC
CAUSE
◾
Insufficient chain
tension.
◾
Dull chain.
◾
Chain installed
backwards.
◾
Worn chain.
◾
Dry or excessively
stretched chain.
◾
Chain is not in bar
groove.
◾
The chain will
become loose as
the temperature of
the chain increases
during normal saw
operation.
◾
Chain does not
engage drive
sprocket.
SOLUTION
◾
Tension the chain following the
chapter "ADJUSTING THE CHAIN
TENSION" until the chain is correctly
tensioned.
◾
Sharpen the chain cutters, following
the section "HOW TO SHARPEN THE
CUTTERS".
◾
Remove the battery pack and reinstall
the saw chain, following the section
"REPLACING THE BAR AND CHAIN".
◾
Remove the battery pack and replace
the chain following the section
"REPLACING THE BAR AND CHAIN".
◾
Check the oil level. Refill the oil tank if
necessary.
◾
Remove the battery pack and reinstall
the saw chain, following the section
"REPLACING THE BAR AND CHAIN".
◾
Tension the chain following the section
"ADJUSTING THE CHAIN TENSION"
until the chain is correctly tensioned.
◾
Remove the battery pack and
reinstall the chain, following the
section "REPLACING THE BAR AND
CHAIN". Ensure that the drive links
on the chain are fully seated onto the
sprocket.
51
Publicidad
