VM Motori MR 506 Manual De Instrucciones Para El Uso página 110

RESTORING OPERATING CONDITIONS AFTER ENGINE STORAGE
Please contact an authorised VM MOTORI FCA
GB
ITALY workshop for the following checks:
- Presence of damage to the external components
of the engine; if necessary, restore the condition of
conformity.
including connections and connected boat compo-
nents (e.g. battery).
- Integrity and tightness of piping, sleeves and as-
sociated clamps; replace damaged parts.
- Fluid level: engine oil (see page 45), engine
(see page 58), to check the fuel level follow the
instructions of the manufacturer of the boat where
the engine is installed.
- Sea water pump (see table on page 35).
- Galvanic anode (see table on page 34 - table on
page 35 and galvanic anode check on page 57).
- Engine start as per procedure on page 27.
- Fluid leaks.
CHECKING TIGHTNESS OF SCREWS, FITTINGS AND SEALING CLAMPS
Follow the procedure below.
1 - To start the engine and keep it at a speed of
1000 / 1200 rpm until it reaches the operating tem-
perature (80°C - 95°C / 176°F - 203°F).
2 - Turn off the engine and let it cool down.
tings and sealing clamps with suitable commercial
equipment.
English
IMPORTANT
Please contact an authorised VM MOTORI FCA
ITALY workshop if needed.
-
44
MR 506
42432070F Ed.1 - Nov. 2019