Fronius TTW 3600 ArcTig Manual De Instrucciones página 29

Commissioning
Safety
Incorrect operation and incorrectly performed work can cause serious injury and
property damage.
► All work listed in these Operating Instructions may only be performed by trained spe-
► All functions described in these Operating Instructions may only be used by trained
► Do not perform the work or use the functions described below until you have thoroughly
An electric shock can be fatal.
Before starting any of the work described in these Operating Instructions:
► Switch the power switch of all power sources to - O -
► Disconnect all power sources from the grid
► Ensure that all power sources remain disconnected from the grid until all work is com-
Risk of burns due to welding torch components and coolant heated during opera-
tion.
► Allow all welding torch components and the coolant to cool down to room temperature
Improper connections can cause personal injury and/or damage to equipment.
► All cables, leads, and hosepacks must always be securely connected, undamaged,
NOTE!
Never use water-cooled welding torches without coolant.
The manufacturer is not responsible for any damage resulting from improper use. All war-
ranty claims are considered void in such cases.
WARNING!
cialist personnel.
specialist personnel.
read and understood the following documents:
these Operating Instructions,
the enclosed "Safety rules" document,
all Operating Instructions for system components, especially the safety rules.
WARNING!
plete.
CAUTION!
(+25 °C or +77 °F) before starting any of the work described in these Operating Instruc-
tions.
CAUTION!
correctly insulated, and adequately sized.
29