Fronius RC Panel Basic Manual De Instrucciones página 43

- Main current I1 (AC/DC-)
- Reduced current I2 (AC/DC-)
- DownSlope tdown (AC/DC-)
- Final current IE
- AC Balance (AC)
- Electrode diameter E- (AC/DC-)
- Cap mode (AC)
- Polarity (AC)
- UpSlope tup (AC/DC-)
- Starting current Is (AC/DC-)
(2) Gas-test button
For setting the required gas flow rate on the gas pressure regulator/for fil-
ling the torch hosepack with shielding gas. When the "Gas-test" button is
pressed, shielding gas will flow for 30 seconds. Press the button again to
stop the gas flow prematurely.
(3) SF indicator
Special function
AC indicator
Status indicator for selected AC polarity
DC- indicator
Status indicator for selected DC- polarity
(4) HF ignition indicator
The HF ignition indicator lights up on the display if the HF ignition setup
parameter has been set to "On".
TAC (tacking) indicator
The tacking (TAC) indicator lights up on the display if the "tacking" para-
meter has been set to a period of time.
Pulse indicator
The pulse indicator lights up on the display if the "Pulse frequency" para-
meter has been set to a pulse frequency.
Cap mode indicator
Lights up if cap mode is active.
(5) Hold indicator
At the end of each welding operation, the actual values for welding cur-
rent and welding voltage are stored - the "HOLD" indicator lights up.
Torch trigger deactivated indicator
The display shows the symbol for the deactivated torch trigger in the sta-
tus bar; the selection of the operating mode is deactivated.
(6) Hz indicator
Displays the set frequency
Arc-force dynamic indicator
To influence the short-circuiting dynamic at the moment of droplet trans-
fer
- ... harder and more stable arc
0 ... neutral arc
+ ... soft and low-spatter arc
Wire speed indicator in m/min or ipm
Displays the selected wire speed
EasyJob number indicator
Displays the selected EasyJob
43