Dreame VTT1 Manual De Usuario página 28

FAQ
EN
I the vacuum is not working properly, please reer to the table below.
Errors
Vacuum does not
work.
Weak suction
orce.
Motor is making a
strange noise.
The battery indicator
does not light up
when charging.
The vacuum charges
slowly.
24
Possible Causes
Vacuum is out o battery or low on
power.
Overheat protection mode triggered
by a blockage.
The suction opening or air
duct is blocked.
Dust cup is ull and/or ilter
assembly is clogged.
Attachment is blocked.
Main suction opening or carbon
iber rod is blocked.
The charger does not plug into
the vacuum well.
The battery is ully charged and
went into sleep mode.
I the problem persists ater ruling
out the above two possibilities.
Battery temperature is too low or
too high.
Solutions
Fully charge the vacuum, then
continue to use it.
Clean the suction openings or air
duct. Wait until the vacuum cools
down, then reactivate it.
Clear any blockage rom suction
opening or air duct.
Empty the dust cup and clean the
ilter assembly.
Clear any blockage in the
attachment.
Clear any blockage in the main suction
opening or extension rod.
Check whether the charger is
properly plugged into the vacuum.
The vacuum can be used normally.
Please contact the ater-
sales service department or
maintenance.
Wait until the battery's
temperature returns normal, then
continue to use the vacuum.