Dreame VTT1 Manual De Usuario página 29

Troubleshooting
I you need to pay attention to any abnormality during the use o the product, a prompt
will be shown on the screen. You should ollow the instructions on the screen to keep the
perormance normal.
Error Icon Error Message
Battery overheating
Roller brush stuck
Air duct blocked
Error
Low battery
The battery runs out
Filter is expiring
Filter uninstalled
Replace the ilter
Solutions
Please wait and continue to use ater motor
temperature is normal.
Reer to the maintenance guide [Cleaning the Smart
Multi-Brush Bar] section to clean the iber material
and hairs wrapped around the roller brush.
Check whether the dust cup, carbon iber rod,
and smart multi-brush bar are blocked.
Please contact the ater-sales department or
maintenance.
Recharge soon.
Recharge soon.
Please replace the ilter in time.
Ensure that the ilter and pre-ilter are installed
correctly.
Reer to the maintenance manual [Cleaning
Filter] section to remove the ilter and replace
it. Ater replacing the ilter, press and hold the
button or 1.5 seconds to enter the countdown
to reset the ilter, then hold the button or
another 5 seconds until
screen.
appears on the
EN
25