John Bean B600 Manual De Operador página 74

74
20
5-33
28
26
5-34
21
5-35
5-36
Operation
5.10.3 Start Optimization/weight
minimization.
procedure:
 Clamp the wheel or bare rim.
 Enter correct rim dimensions, or check existing
inputs for correctness.
 Close the wheel guard (if necessary press the
START key).
 Starting from the BALANCING menu press key 20
Optimization – Minimization (Fig. 5-33).
The Optimization MENU "OP.1" screen (Fig. 5-34) is
displayed.
If an Optimization/weight minimization result has
already been saved, press the 21 key (Fig. 5-35);
The program then continues from the step where it
was interrupted, with the relative measurement values
and the balancing Optimization / weight minimization
may continue.
At this point, you can choose whether to continue with
Optimization (Key 26), or go to Minimization (Key 28).
5.10.3.1 Optimization
 Clamp the rim only.
 Move the gauge arm into position on the rim, based
on the desired ALU.
 Perform a measuring run.
 In the BALANCING menu press key 20 (Fig. 5-33).
The "OP.1" screen page appears (Fig. 5-34).
 Press the menu key 26 (Fig. 5-34).
The OPTIMSATION "OP.2" screen (Fig. 5-36) is
displayed.