Tabla de contenido
Publicidad
88
26
5-55
26
5-56
26
5-57
5-58
5-59
Operation
Fig. 5-55 Minimization "Un.6"
Rotate the wheel into marking position following
the arrows.
In this position mark the tire, on the outer side of
the wheel, precisely above the main shaft.
Confirm by pressing the key 26.
The Minimization "Un.7" screen (Fig. 5-56) is displayed.
Fig. 5-56 Minimization "Un.7"
On the tire changer, turn the tire relative to the
rim until the valve is aligned with the mark made
on the tire.
Confirm by pressing the key 26.
The Minimization "Un.8" screen (Fig. 5-57) is displayed.
Fig. 5-57 Minimization "Un.8"
Clamp the wheel on the balancer.
Rotate the wheel such that the valve is exactly
perpendicular to and above the main shaft.
Enter the valve position by pressing the key 26.
The Minimization "Un.9" screen (Fig. 5-58) is displayed.
Fig. 5-58 Minimization "Un.9"
START is signalled on the screen.
Spinn the wheel.
A measuring run is performed.
The screen Minimization "Un.10", outside (Fig. 5-59)
or the screen Minimization "Un.10", inside (Fig. 5-61)
is displayed.
Reading H 0
Optimum condition has been achieved and cannot be
improved.
Continue as shown on screen BALANCING
(Fig. 5-51).
Publicidad
Tabla de contenido
