cecotec COOLMARKET COMBI 322 INOX E Manual De Instrucciones página 69

side, unscrew the screw (22) and remove the dowel (21) from the door stop (20). On the
lower door's left side, insert the left door stop (23) and the left dowel (19) (included in the
plastic bag) and secure it with the screw (15). Keep the right door stop and dowel Fig. 15
11. Replace the screw gap covers and screw the centre plate to the right. Fig. 16
12. Tilt the refrigerator carefully to gain access to its base. Remove the two adjustable lower
legs (27), then remove the lower hinge (25) by unscrewing the screws (26). Fig. 17
13. Loosen the lower hinge pin and remove it. Rotate the hinge and reinsert the lower hinge
pin (28), then tighten it. Fig. 18
14. Place the lower hinge on the left side of the refrigerator base and secure it with the screws
(26). Replace the adjustable lower legs and partially secure them. Fig. 19
15. Place the refrigerator in an upright position and carefully insert the lower door into the
upper hinge of the lower door. At this point, the door will not be attached to the refrigerator.
Hold it firmly so that it does not fall off. Install the left hinge (in the plastic bag) making sure
that the lower door is secured in place. Fig. 20
16. Position the upper door on the left side and place the middle hinge shaft in the upper
door's bottom hole. Install the upper-left hinge (29) (included in the plastic bag) and screw
it with the screws removed in step 9 (6). At this point, the door will not be attached to the
refrigerator, but hold it firmly so that it does not fall off. Fig. 21
17. Remove connectors 31 and 32 from the top left side of the refrigerator. Connect 30 to 31.
Then plug connector 32 to the door switch located on the upper-left hinge cover. Fig. 22
18. Install the upper left hinge cover (5) using the screw (33) as shown in figure 23, on the top
of the refrigerator. Fig. 23
19. Open the upper door, reinstall the shelves, and close the door.
Please note
- If the refrigerator has a handle, you must reverse its position by following these
instructions:
- Remove the covers from the handle screws and then loosen the screws. Pull the handle to
remove it and replace it on the right side. Screw the screws back in and place the covers.
Fig. 24
Fig. 24
1. Handle covers
2. Special screws
3. Door handle
4. Screw gap
BOLERO COOLMARKET COMBI 322 WHITE E / INOX E / DARK E
ENGLISH
69