Pioneer PDP-508XG Manual De Instrucciones página 19

Watching TV
Chapter 6
Watching TV
Important
• Before watching broadcast channels, the built-in TV tuner
must be set up. See Setting up TV channels automatically on
page 25 for how to do this.
Turning the power on
• Press  on the plasma television when the POWER ON and
STANDBY indicators are off.
• The system is on.
• The POWER ON indicator lights up blue.
Press  or 0 to 9 on the remote control unit or STANDBY/
•
ON on the plasma television if the STANDBY indicator lights
red.
• The POWER ON indicator lights up blue.
• If you press 0 on the remote control unit, images from "INPUT 1"
will be displayed.
• If you press 1 to 9, TV images will be displayed.
PDP-508XG
ON STANDBY
button
Placing the system into standby
Press  on the remote control unit or STANDBY/ON on the
plasma television.
• The STANDBY indicator lights up red.
• The system enters the standby mode and the image on the
• When  on the plasma television is off, you cannot turn the
• If you are not going to use the plasma television for a long
Plasma television status indicators
The table below shows the operational status of the plasma
television. You can check the current status of the system with the
indicators on the plasma television.
POWER ON
POWER ON indicator
STANDBY indicator
For other than the above, see Troubleshooting on page 63.
PDP-428XG
ON STANDBY
button
screen disappears.
Note
power on by pressing  or 0 to 9 on the remote control unit or
STANDBY/ON on the plasma television.
period of time, be sure to remove the power cord from the
power outlet.
Indicator status
STANDBY
The power cord of the plasma television has been
disconnected. Or, the power cord of the plasma
television has been connected but the
of the plasma television is off.
Power to the system is on.
The system is in the standby mode.
06
POWER ON indicator
STANDBY indicator
System status

button
19
En