Nussbaum WA 780 Manual De Instrucciones página 109

The programme exclusively prompts for
confirmation to perform the procedure if, in
the set-up settings, the "Richiedi conferma
prima di archiviare" ("Confirmation request
before filing") option is selected, in the box
"F" figure 44; otherwise, the procedure is per-
formed without the user noticing anything.
In this case, the confirmation request is set-
up in the "Save Data" set-up; the following
message will be displayed before performing
filing, at the end of the period that was set
up, upon aligner start-up: "Data filing...Want
to perform it?".
• Press "F3" if you want to perform the "Save
Data" procedure.
• Press "F2" if you do not want to perform
the "Save Data" procedure.
"Reset Data" procedure (Restore)
The "Reset Data" procedure can be exclu-
sively performed in manual mode.
Before resetting data, the machine performs
a backup of the data to be replaced. To
restore the backup, contact the technical
assistance service.
To perform the "Reset Data" (Restore)
procedure, follow the instructions below
thoroughly:
1. From the starting screen (Logo screen),
open the drop-down menu, pressing
"F11".
2. Select "Setup" with the ↑ or ↓ arrows.
3. Press "F3" to confirm.
4. Wait until the aligner general set-up
screen is displayed.
5. Open the drop-down menu, pressing
"F11".
6. Select "Ripristino Dati" ("Store Data")
with the ↑ or ↓ arrows.
7. Press "F3" to confirm.
The screen on figure 38 will be displayed
User Manual WA 780 - Cura S 780
N.B.: To move through the different ob-
jects (boxes) present on the screen, use
the tab key.
The programme always suggests restoring
the last "Save Data" procedure performed
(obviously, if the path is available, it may
not be available if the "Save Data" is per-
formed on a removable device; for example,
a USB support).
If you wish to select the disc and the folder
where to restore the "Save Data" procedure,
proceed as follows; otherwise, proceed
from step 8.
N.B.: The destination path of the files to
be restored, not set, regarding the restore
programme, automatically positions the
file in the correct work position.
a) Use the ↑ or ↓ arrows to select the
disc from which you wish to recover
"Stored data" in field "B", Figure 38.
b) Use the ↑ or ↓ arrows to select the
folder from which you wish to recover
"Stored data" in field "C", Figure 38.
The name of the folder to be searched is
generated following the rules below:
for example: BU_31102006_170653
where
BU_ indicates BackUpBU
31102006_ indicates ddmmyyyy
170653 indicates hhmmss
c) Press "F3" to confirm.
d) The path where to restore the data filed
is displayed in full in the field "A" Figure
38.
A B C
D
38
GB
109