Nussbaum WA 780 Manual De Instrucciones página 75

plane of the vehicle (longitudinal upright
angle).
The caster is measured with the wheels
turned. The unit of measurement is de-
grees.
4) King pin angle (Fig. 13)
This is the angle formed between the
vertical and the extension of the steering
axis on the transverse plane of the vehi-
cle (transverse upright angle).
The king pin angle is measured with the
wheels turned. The unit of measurement
is degrees.
5) Steering angle difference. (TOE-OUT
ON TURN) (Fig.14)
Steering angle toe difference on the front
wheels. The unit of measurement is de-
grees.
User Manual WA 780 - Cura S 780
6) Set-back or misalignment of wheels
on the same axle (Fig.15)
This measurement shows the difference
in position of one wheel with respect to
the other on the perpendicular of the
12
longitudinal axis of the vehicle.
There are both front set-back and rear
set-back; although rear set-back must not
be confused with the thrust angle.
The unit of measurement is degrees.
7) Thrust angle. (Fig.16)
This is the angle formed between the axis
of symmetry of the vehicle and the travel
direction of the rear axle.
The unit of measurement is degrees.
13
14
15
GB
16
75