Descargar Imprimir esta página

identités 826186 Manual De Instrucciones página 7

Andador 2 ruedas classic aluminio

Publicidad

Idiomas disponibles

Idiomas disponibles

No modification must be made on this device. Use only original parts to replace the broken or defect one and let this be
done by the technical staff.
In case you didn't use your walking aid for a long time, let it checked by the technical staff, before using.
Be careful when using: beware holes and deformations in the floor.
Be careful: risk of crushing and squeezing fingers when folding/ unfolding.
Make sure that the knobs are tightened to the same level and the handles are securely fastened.
Do not use the rollator to walk backwards.
Do not make any adjustments to the rollator while it is in use.
All wheels should always be in contact with the ground.
Make sure the seat is clipped flat before use.
Do not use the seat to carry objects.
Do not sit on the seat when the rollator is on a slope.
When sitting, do not try to reach objects by leaning forward. Do not lean backwards as this can cause the rollator to tip
over.
Be careful when climbing pavements or walking on sloping, uneven, or slippery surfaces. Failure to do so may result in a
significant risk of falling or injury.
Do not use the rollator on a wet, icy, or snowy slope.
If any parts are damaged, broken or worn, contact the dealer.
MOUNTING & USE
Only specialists can adjust the product and teach you how to use it. A wrong use or adjustment could lead to
overstress of the device or of the patient.
The device must be adjusted individually by the technical staff to suit your needs. Ask the technical staff how
to use this product and make sure that you understood clearly their explanation.
In case of doubt, don't hesitate to ask again. Depending on the model chosen, the rollator may have a seat or
not.
Opening
Pull the legs of the rollator backward [1]. Check that the locking mechanisms located on each side of the rol-
lator are horizontal and correctly locked [2]. Check stability before using.
Pushing anatomic handles
1-Position the pushing anatomic handle so that when the user's arm is down to their side the handgrip is at
wrist height.
2. Install the adjustment knob into one of the adjustment holes and into the locknut by turning clockwise.
Folding
To fold the rollator, lift up the seat [3] and pull up on the strap under the seat until the rollator closes [4].
DMI-F-12_Annexe 2_Notice.3
7

Publicidad

loading