Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Possible cause
The control knob is not set
properly.
Surface burners do
The burner caps are not
not light.
in place.
The burner base is
misaligned.
Surface burner
The control knob has been
clicks during
left in the Lite position.
operation.
Surface burner
components and caps are
not assembled correctly
The burners do not
and level.
burn evenly.
Surface burners are dirty.
Very large or yellow
Wrong orifice is
surface burner
assembled.
flames.
Surface burners
The Gas Pressure
light but oven
Regulator shut off switch
burners do not light.
is in the OFF position.
52 English
DOP36P86DLS_DA_DG68-01105E-00_EN+MES+CFR.indb 52
Solution
Push in the control knob and turn it to
the Lite position.
Clean the electrodes.
Put the burner cap on the burner head.
Align the burner base.
After the burner lights, turn the control
knob to a desired setting.
If the burner still clicks, contact a
service technician.
See page 46.
Clean surface burner components.
(See page 46.)
Check the burner orifice size and
contact your installer if you have the
wrong orifice (LP gas instead of natural
gas or natural gas instead of LP gas).
Call a qualified service technician.
Oven
Problem
Possible cause
The oven control
There may be an issue
beeps and the
with your oven. See the
oven control
Information codes chart
display shows an
on page 54.
information code.
The oven is not
completely plugged into
the electrical outlet.
The oven will not
turn on.
A fuse in your home may
be blown or the circuit
breaker may have tripped.
The oven temperature
Oven temperature
needs to be adjusted and
is too hot or cold.
recalibrated.
Loose or burned-out bulb.
Oven light (lamp)
The switch button
will not turn on.
operating the oven light
needs to be replaced.
Meat or food not properly
prepared before broiling.
Oven smokes
Improperly positioned top
excessively during
oven rack.
broiling.
Greasy buildup on oven
surfaces.
Solution
Rotate both the mode and temperature
selector knobs to the OFF position
and restart the oven. If the problem
persists, disconnect all power to the
range for at least 30 seconds and then
reconnect the power. If this does not
solve the problem, call for service.
Make sure the electrical plug is fully
inserted into a live, properly grounded
outlet.
Replace the fuse or reset the circuit
breaker.
See page 43.
See page 51.
Call for a qualified service technician.
Cut away excess fat and/or fatty edges
that may curl.
See the Broiling guide on page 27.
Regular cleaning is necessary when
broiling frequently. See page 34.
2020-07-06 오후 3:53:58
Publicidad
