cecotec DRUMFIT INDOOR 4000 MAGNETIC CONNECTED Manual De Instrucciones página 52

ENGLISH
Box content
- Drumfit Indoor 4000 Magentic Connected stationary bicycle
- Assembly tools
- Instruction manual
3. PRODUCT ASSEMBLY
Stabilisers installation. Fig. 3
1. Remove the pre-installed hex head screws from the stabiliser with the 6 mm Allen key
(S4) provided.
2. Align the main frame screw holes with the stabiliser screw holes. Install the hex head
screws and curved washers and tighten them with the 6 mm (S4) Allen key provided.
Handlebar stem installation. Fig. 4
1. Remove the pre-installed hex head screws from the handlebar stem with the 5 mm Allen
key (S4) provided.
2. Align the main frame screw holes with the handlebar stem holes. Install the hex head
screws and curved washers and tighten them with the 6 mm (S4) Allen key provided.
Handlebar and tablet holder installation. Fig. 5
1. Align the handlebar screw holes with the handlebar stem holes. Install the hex head
screws, plain washers, and the spring washers, and tighten them with the 5 mm (S4)
Allen key provided.
2. Attach the tablet holder to the handlebars.
Pedals and saddle installation. Fig. 6
1. Insert the pedals into the crank and secure them with the (S5) Spanner provided.
Warning: the pedals are distinguished between left (L) and right (R) with the corresponding
letters. Do not install them in the wrong position.
2. Insert the saddle into the handlebar stem and tighten the screws using the spanners
provided.
Warning: the saddle inclination can be adjusted.
4. OPERATION
Adjusting the resistance. Fig. 7
To adjust the resistance level, simply use the adjustment knob on the main frame. To increase
the tension, turn the knob clockwise (+); to decrease the tension, turn it counterclockwise (-).
Press the knob to stop the stationary bike from moving.
52
DRUMFIT INDOOR 4000 MAGNETIC CONNECTED