Fronius MTG 320i US Manual De Instrucciones página 41

4
Fit the contact tip and gas nozzle; mark the inner liner at the end of the PowerPin
Final tasks - Miller:
5
Cut and deburr the inner liner at the previously marked position; make sure that no burr protrudes
into the inner liner
6
Screw the end cap onto the inner liner
- The welding torch can now be connected to a Miller welding system. To do so,
see the Operating Instructions for the respective welding system.
- For information on connecting the control line, see the following section
Connecting the welding torch
7
Push the inner liner into the welding torch fully
and secure the end cap in the PowerPin
41