Publicidad
Idiomas disponibles
Idiomas disponibles
Malfunction of the torch trigger
Cause:
Faulty plug connections between the welding torch and the power
source
Remedy:
Establish correct plug connections/send power source or welding
torch to service team
Cause:
Soiling between torch trigger and torch trigger housing
Remedy:
Remove soiling
Cause:
Faulty control line
Remedy:
Notify service provider
Porosity of weld seam
Cause:
Spattering in the gas nozzle, causing inadequate gas shield for weld
seam
Remedy:
Remove welding spatter
Cause:
Holes in gas hose or imprecise gas hose connection
Remedy:
Replace gas hose
Cause:
O-ring at central connector is cut or faulty
Remedy:
Replace O-ring
Cause:
Moisture/condensate in the gas line
Remedy:
Dry gas line
Cause:
Gas flow too strong or weak
Remedy:
Correct gas flow
Cause:
Inadequate quantity of gas at the start or end of welding
Remedy:
Increase gas pre-flow and gas post-flow
Cause:
Rusted or poor quality wire electrode
Remedy:
Use high-quality wire electrode without soiling
Cause:
Applies to gas-cooled welding torches: Gas leakage with non-isolated
inner liners
Remedy:
For gas-cooled welding torches, only use isolated inner liners
Cause:
Too much parting agent applied
Remedy:
Remove excess parting agent/apply less parting agent
51
Publicidad
