Publicidad
Idiomas disponibles
Idiomas disponibles
Final tasks - Lincoln and Hobart:
5
Cut and deburr the inner liner 8 mm (0.315 inches) behind the previously marked position; ensure
that no burr protrudes into the inner liner
6
Screw the end cap onto the inner liner
8
Remove the mounting aid
-
-
42
The welding torch can now be connected to a Lincoln / Hobart welding sys-
tem. To do so, see the Operating Instructions for the respective welding sys-
tem.
For information on connecting the control line, see the following section
Connecting the welding torch
7
Push the inner liner into the welding torch fully
and secure the end cap in the PowerPin
Publicidad
