Installation Precautions - Pioneer PDP-5050SX Manual De Instrucciones

Safety Precautions

Installation Precautions

Observe the following precautions when installing with any items such as the optional stand.
When using the optional stand, brackets, or equivalent items
• Ask your dealer to perform the installation.
• Be sure to use the supplied bolts.
• For details, see the instruction manual that comes with the optional stand (or equivalent items).
When using other items
• Consult your dealer.
• The following six mounting holes can be used for the installation:
Rear view
Mounting hole
• Be sure to use four or more mounting holes symmetrical to the vertical and horizontal median lines.
• Use M8 screws, which go 12 to 18 mm (1/2 to 11/16 inches) in depth from the mounting surface of the Plasma Display. See the
side view above.
• Be careful not to block the ventilation opening at the rear of the Plasma Display.
• Be sure to install the Plasma Display on a flat surface because it contains glass.
• The screw holes other than the above are to be used only for the specified products. Never use them for mounting non-specified
products.
• Do not mount or remove the Plasma Display to or from the stand, with speakers attached.
• It is strongly recommended to use the optional PIONEER mounting products.
• PIONEER shall not be liable for any personal injury or product damage that results from the use of mounting items other than the
optional PIONEER products.
04-PDP5050SX-Eng (06-11)
Median line
9
Side view
Mounting hole
Median line
05.2.25, 9:50 AM
Mounting surface
Mounting
Plasma bracket (or
Display equivalent item)
M8 screw
12 to 18 mm
(1/2 to 11/16 inches)
02
9
En