Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Preparation
Please check the appliance for damage caused
during transport or any damage or defects immedi-
ately after delivery.
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire compartment, fire basket, ash removal
port and ash pan) from the appliance before you
start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of the removable parts, so
that you can re-position the parts in the
correct place later on.
1. Remove the appliance from the pallet by
removing the bolts (1).
2. Remove the mounting brackets (2) by turning the
adjustable feet (3) out.
3. Reassemble the adjustable feet (3).
4. Open the door; see the following figure.
Subject to change because of technical improvements
5. Remove the fire-resistant inner plates; see the
following figure:
a. Remove the fire basket (6).
b. Lift the left baffle plate (1), slide the right
baffle plate (2) to the left and remove.
Remove the other baffle plate (1).
c. Pull the left rear plate (3) forwards from the
centre and remove. Pull the right rear plate
(4) forwards from the centre and remove.
d. Remove the left inner plate (5) Remove the
right inner plate (6,8)
e. Remove the inner plate of the side filling door
(7)
f. Remove the ash removal port (9)
g. Remove the stove base (11,12)
h. Remove the ash pan (13)
Vermiculite inner plates are light and tend
to be ochrous in colour on delivery. They
insulate the combustion chamber to boost
combustion.
D OVRE
11
Publicidad
