Publicidad
Idiomas disponibles
Idiomas disponibles
EN
70
To remove the multifunction knife, proceed as follows:
1
Place the blender jar in the correct orientation onto the unit base and secure.
2
Grasp the top of the blade post, press down firmly, rotate clockwise, and then
pull straight up to remove.
Note: The blender jug must be firmly seated on the base of the appliance,
otherwise you will not be able to remove the blade.
Dough hook
The dough hook is mainly used for kneading dough.
Note: Do not use the dough hook above speed 3.
To install the dough hook, do the following:
1
Place the blender jar in the correct orientation onto the unit base and secure.
2
Grasp the top of the blade post.
3
Lower the dough hook over the drive coupler in the bottom of the blender jar,
making sure the tabs on the drive coupler line up with the slots in the bottom
of the dough hook. Then press down firmly and turn anti-clockwise until it
clicks into place.
Publicidad
