Publicidad
Machine Set-up Guide
!
Fitting the Brush / Pad
Brush Deck Pitch Adjustment
If the machine has a tendency to pull to either side while cleaning forwards,
this can be compensated for by turning the brush deck pitch adjustment knob.
Fitting the Floor Tool
Fit the floor tool and retain using the
detent pin.
Push vacuum hose onto the floor tool;
ensure a tight fit.
Note: DO NOT push the vacuum hose
onto the floor tool with the floor tool in
the raised position.
Raise the floor tool for transit or
lower for cleaning operation using
the lifting handle fitted to the back
of the machine.
For fitting the floor tool blades
(See P57)
.
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
Note: Safety gloves are recommended for the changing of used brushes.
LH Bias: If the machine pulls
to the right, turn the knob
clockwise to apply left hand
bias to the brush deck.
RH Bias: If the machine pulls to
the left, turn the knob counter-
clockwise to apply right hand
bias to the brush deck.
The floor tool has been designed for quick fitting, allowing easy squeegee blade
replacement and a safety knock-off feature if the floor tool gets snagged, whilst in transit.
2 x 370mm Brush or a 2 x 360mm Pad on
the TBL8572. Featuring the Nulock brush
system. The brush is simply pushed and
twisted to lock, making fitting and removal
a simple process.
Slide the brush / pad under the brush deck.
Fit the brush / pad onto the Nulock drive
chuck, twist to lock the brush / pad in place.
L
Turning the knob
clockwise will make
the machine pull
more to the left.
22
22
EN
!
R
Turning the knob
counter-clockwise
will make the
machine pull more
to the right.
Publicidad
