Publicidad
Idiomas disponibles
Idiomas disponibles
Leveling the Mower Deck
Ensure that the mower deck is level any time you install the mower deck or when you see an
uneven cut on your lawn.
Preparing to Level the Mower Deck
1. Park the machine on a level surface, disengage the blade-control switch (PTO), and
engage the parking brake.
2. Shut off the machine, remove the key, and wait for all moving parts to stop before
leaving the operating position.
3. Remove the battery packs from the machine.
4. Ensure that the tires are inflated to the correct specifications and the caster wheels are
facing straight forward.
5. Check the mower deck for bent blades; remove and replace any bent blades.
6. Raise the mower deck to the 76 mm (3 inch) height-of-cut setting.
Checking the Mower-Deck Level
1. Position the blades side-to-side.
2. Measure at locations
surface to the cutting edge of the blade tips
The difference between the measurements
should be no more than 5 mm (3/16 inch). If
the measurement is larger, adjust the side-to-
side level.
3. Position 1 blade front-to-rear.
4. Measure at locations
surface to the cutting edge of the blade tips
The front blade tip should be 1.6 to 7.9 mm (1/
16 to 5/16 inch) lower than the rear blade tip. If
the measurement is not correct, adjust the
front-to-rear level.
Maintenance: Mower-Deck Maintenance
and
from a level
and
from a level
Page 5–10
.
G414698
.
G414700
3463-565 A
Publicidad
