Publicidad
Idiomas disponibles
Idiomas disponibles
[ie See
ree
SER Nt
PONE Te i a
Inserting the
Batteries
Install two R6 (size AA) batteries in the
supplied remote for remote control.
1 Open the lid.
2 Insert two R6 (size AA) batteries.
Match the + and — indications to the
diagram in the battery compartment.
3 Close the lid.
Battery life
You can expect the remote to operate for
about six months (using Sony SUM-3 (NS)
batteries) before the batteries run down.
When the batteries no longer operate the
remote, replace all the batteries with new
ones.
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.
Chapter 1: Setting Up
Setting the Clock
The built-in clock shows the time in the
display even if the power is off. You need
to set the clock to utilize the timer-activated
features of your stereo system. The clock
shows the time in the 24 hour cycle.
Use the buttons on the unit to do this
operation.
DISPLAY/DEMO
Q
2
'1 Press TIMER.
2 Press CLOCK SET.
The hour indication begins flashing.
flashing
3 set the current
hour by turning
the JOG
dial until the correct hour appears.
flashing
4 Press ENTER/ NEXT.
The minutes indication begins flashing.
flashing
5 set the current minute by turning the
JOG dial until the correct minute
appears.
flashing
6 Press ENTER/NEXT.
The clock starts running and the upper
dot flashes. Use the time signal to set the
clock accurately.
The upper dot flashes for the first half of
a minute (0 to 29 seconds}, and the
lower dot flashes for the last half of a
minute {30 to 59 seconds).
flashing
To check the time
Press DISPLAY /DEMO a few times.
The current time is displayed for eight
seconds.
To correct the clock setting
Repeat steps 1 through 6.
Publicidad
