Publicidad
Idiomas disponibles
Idiomas disponibles
Installing/removing the edge
guide assembly (see figure G)
a
Turn the lock lever of the edge guide
assembly to the left.
b
Insert the hook of the edge guide
assembly into the edge guide slot.
c
Turn the lock lever to the right.
d
To remove the edge guide assembly,
turn the lock lever to the left and then
remove it.
If the connection of edge guide assembly is
loose, with the lock lever in the right-most
position, pull the lock lever away from the
hook and rotate it to the left. Then release the
lock lever and turn it to the right (see figure H).
If the edge guide assembly could not be
removed easily, with the lock lever in the
left-most position, pull the lock lever away
from the hook and rotate it to the right. Then
release the lock lever and turn it to the right
(see figure I).
Installing/removing the dust
extraction hood (see figure J)
The dust extraction hood allows connection
of a 32 mm vacuum hose or adaptor.
a
Insert the peg on the left side of the dust
extraction hood into the slot on the left
side of the base.
b
Snap the right side of the hood with the
screw knob onto the right side of the
base.
c
Tighten the screw knob.
To remove the dust extraction hood,
d
reverse the procedure.
Installing/removing the subbase
(see figure K)
a
Align the holes on the subbase with the
holes at the bottom of the tool.
b
Thread in but do not tighten the screws.
c
Insert the pin of the centering cone into
the collet and tighten the collet nut.
d
Open the base lock lever and turn the
depth adjustment ring until the centering
cone stops and centers the subbase
e
Close the base lock lever and tighten the
screws.
f
To remove the subbase, just loosen and
remove the subbase screws.
20
Template guides (not provided)
(see figure L)
The round subbase will accept universal
template guides. Use only a maximum 30.5
mm template guide with this tool.
The D-shaped subbase does not accommodate
template guides and is designed to
accommodate bits up to 38 mm in diameter.
a
Center the round subbase.
b
Insert the template guide into the
center hole of the round subbase and
secure according to the template guide
instructions.
Adjusting the depth of cut (see
figure M&N)
a
Install the bit.
b
Open the base lock lever.
c
Turn the depth adjustment ring until the
bit just touches the work piece.
d
Turn the depth adjustment scale
clockwise until the zero mark on the scale
lines up with the pointer on the depth
adjustment ring (see figure L).
e
Turn the depth adjustment ring
counterclockwise until the pointer lines up
with desired depth of cut marking on the
depth adjustment scale (see figure M).
Each mark on the depth adjustment scale
represents a depth change of 1/64" (0.4
mm) and one full (360°) turn of the ring
changes the depth by 1/2" (12.7 mm).
f
Close the base lock lever.
Variable speed dial (see figure O)
Turn the variable speed dial to control the
router speed.
1-2 (Low Speed): 15000-17000 rpm
3-4 (Medium Speed): 20000-23000 rpm
5-6 (High Speed): 25000-30000 rpm
The speed dial is numbered "1" to "6", with
position "1" being the lowest speed and
position "6" being the highest speed.
WARNING!
Never change the speed while the tool is
running. Failure to obey this could make you
lose of control of the tool and result in serious
personal injury and property damage.
CER 18-EC
Publicidad
