Publicidad
Idiomas disponibles
Idiomas disponibles
e
Pivot the tool clockwise around the nail
to make the circle cut (Fig. V).
Internal routing (See figure W)
a
With the cutting depth set, tilt the tool
and place it on the workpiece, with
only the leading edge of the subbase
contacting the workpiece.
b
Turn on the tool and allow it to reach its
full speed, being careful not to allow the
cutter bit to contact the workpiece.
c
To begin the cut, gradually feed the
cutter bit into the workpiece until the
subbase is level with the workpiece, then
move the router to make the cut.
Feeding the trim router
■ Direction of feed (see figure X)
Feeding the tool in the opposite direction
may cause loss of control, resulting in possibly
personal injury.
■ Rate of Feed
The proper rate of feed depends on several
factors: the hardness and moisture content
of the workpiece, the cutting depth, and the
cutting diameter of the bit. Use a faster rate
of feed when cutting shallow grooves in soft
woods, such as pine. Use a slower rate of feed
when making deep cuts in hardwoods, such
as oak.
Maintenance and care
WARNING!
Before performing any work on the power
tool, remove the battery pack from the tool.
Cleaning
CAUTION!
When cleaning with compress air, always
wear goggles.
Regularly clean the power tool and ventilation
slots. Frequency of cleaning is dependent on
the material and duration of use. Regularly
blow out the housing interior and motor with
dry compressed air.
Repairs
Repairs may be carried out by an authorized
customer service centre only.
22
Spare parts and accessories
Other accessories, in particular tools and
accessories, can be found in the manufacturer's
catalogues. Exploded drawings and spare-part
lists can be found on our homepage:
www.flex-tools.com.
Disposal information
WARNING!
Render redundant power tools unusable:
battery operated power tool by removing
the battery.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal
options!
CER 18-EC
Publicidad
