Publicidad
Idiomas disponibles
Idiomas disponibles
CER 18-EC
Instructions for use
WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power
tool
Unpack the power tool and accessories and
check that no parts are missing or damaged.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge the
batteries fully. Refer to the charger operating
manual.
Inserting/replacing the battery
■ Press the charged battery into the power
tool until it clicks into place (see figure B).
■ To remove, press the release button (1.) and
pull out the battery (2.) (see figure C).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short
circuit the contacts; explosion and fire hazard!
Battery state of charge
■ Press the button to check the state of
charge at the state of charge indicator LEDs.
(see figure D).
If one of the LEDs flashes, the battery must be
recharged. If none of the LEDs light up after
the button is pressed, the battery is faulty
and must be replaced. The indicator goes out
after 5 seconds.
NOTE
Follow the instructions for charging the
battery set out in the charger operating
manual.
Base quick release (see figure E)
a
Open the lock lever
b
Depress both quick release tabs and pull
the base from the motor.
c
To install the base, push the base unit
down onto the unit until you hear a
"click". Then close the lock lever. It is
recommended to make the spindle lock
face the dust outlet for easy operation.
Installing/removing bits (see
figure F)
WARNING!
Use protective gloves when removing the
bit from the tool, or first allow the bit to cool
down.
This router is shipped with a 6.35mm collet
and a 8mm collet that accepts cutter bits
with 6.35mm shanks and 8mm shanks,
respectively.
a
Remove the base
b
Slide the spindle lock down or use the 12
mm wrench to hold the spindle securely.
c
Use the 17 mm wrench to turn the collet
nut counterclockwise.
d
Install or remove the bit/collet as follows:
To install a bit, clean and insert the
round shank of the desired router bit into
the collet so that the cutting surfaces are
approximately 3.2 mm to 6.4 mm away
from the face of the collet.
To remove the bit, pull the bit out of the
collet.
e
Turn the collet nut clockwise to tighten
the bit.
f
Slide the spindle lock up.
g
Install the base.
WARNING!
Tighten the collet nut securely to prevent the
cutter bit from slipping. If the collet nut is not
tightened securely, the cutter bit may detach
during use, causing serious personal injury.
NOTE
To prevent damage to tool, do not tighten the
collet nut without a cutter bit installed.
NOTE
To ensure proper gripping of the cutter bit
shank and minimize run-out, the shank of the
cutter bit must be inserted at least 16 mm into
the collet.
NOTE
The tool could be started only when the
spindle lock is released. The LED lights will
flash to signal that the spindle is locked when
the On/Off switch is pressed.
19
Publicidad
