Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a measurement method
standardised in EN 62841 and may be used
to compare one tool with another.
That the declared vibration total value(s) and
the declared noise emission value(s) may
also be used in a preliminary assessment of
exposure.
However, if the tool is used for different
applications, with different cutting accessories
or poorly maintained, the vibration emission
level may differ.
This may significantly increase the exposure
level over the total working period.
To make an accurate estimation of the vibration
exposure level, it is also necessary to take into
account the times when the tool is switched off
or running but not actually in use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration
such as: maintain the tool and the cutting
accessories, keep the hands warm, organisation
of work patterns.
WARNING!
that the vibration and noise emissions
during actual use of the power tool
can differ from the declared values
depending on the ways in which the tool
is used especially what kind of workpiece
is processed; and
of the need to identify safety measures
to protect the operator that are based on
an estimation of exposure in the actual
conditions of use(taking account of all
parts of the operating cycle such as the
times when the tool is switched off and
when it is running idle in addition to the
trigger time).
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).
18
Technical data
Tool
Type
Rated voltage
Collet capacity
No-load speed
Weight according
to "EPTA Procedure
01/2003" (without
battery)
Battery
AP 2.5
Weight of
0,42
battery/kg
Working
-10~40°C
Temperature
Charging
4~40°C
Temperature
Storage
<50°C
Temperature
Charger
CA 10.8/18.0, CA 18.0-LD
Overview (see figure A)
The numbering of the product features refers
to the illustration of the machine on the
graphics page.
1
On/Off switch
2
Depth adjustment ring
3
Depth adjustment scale
4
Base lock lever
5
SPINDLE STOP™ Spindle lock
6
6.35 mm Collet
7
D-Shaped subbase
8
Quick release tab (x2)
9
Variable speed dial
10 Edge guide slot
11 LED lights
12 Edge guide assembly
13 Dust extraction hood
14 Centering cone
15 Round subbase
16 17mm Wrench
17 12mm Wrench
18 8 mm Collet
CER 18-EC
CER 18-EC
Trim Router
Vdc
18
6.35
mm
8
Up to
/min
30000
kg
1.6
AP 5.0
AP 8.0
0,72
1,18
Publicidad
