Dreame X40 Ultra Manual De Usuario página 14

Before Use
EN
4. Connect the Robot to the Base Station
Press and hold the button
the robot onto the base station with the mop assembly facing toward
the washboard. Then you will hear a voice notification when the robot
successfully connects to the base station.
Note: It is recommended to fully charge the robot before its first use. When
the robot cannot be turned on after the battery is depleted, manually connect
the robot with the station to charge it.
5. Add the Cleaning Solution
(1) Remove the dust tank cover and pull out the auto-detergent compartment.
(2) Open the upper lid of the compartment and add the cleaning solution.
(3) Close the lid of the compartment, put it back into the base station, and
then reinstall the dust tank cover. The cleaning solution will be added
12
on the robot for 3 seconds to turn it on. Place
automatically while working.
Note:
· Do not add any liquid other than the officially-approved cleaning solution
to help prevent malfunction.
· Install the auto-detergent compartment until it clicks into place.
6. Add Water to the Clean Water Tank
Take out the clean water tank from the base station and fill up the tank with
clean water. Then install it back into the base station.
Note: Do not add hot water into the water tank, as this may cause the tank to
become deformed.