Dreame X40 Ultra Manual De Usuario página 18

How to Use
EN
3. Automatically empty the dust box and wash and dry the mop
pads
After the robot finishes a cleaning task and returns to the base station to
charge, the base station will automatically start emptying the dust box. Then
it will wash and dry the mop pads.
Note:
·
If the auto-empty function is turned off in the app, the base station will not
automatically empty the dust box.
·
The base station will empty the dust box according to the setting in the app.
4. Clean the used water tank
After the robot has completed its task, please clean the used water tank to
prevent any odor.
16
Mop after Vacuuming
Enable the mopping after vacuuming function in the app, and the robot will
automatically remove the mop assembly on the base station to vacuum the
floor. After vacuuming is completed, the robot will return to the base station
to install the mop assembly and the base station will automatically start
emptying the dust box. And then, the robot will start mopping after the main
brush and side brush are raised.
Vacuum Only
Enable the vacuuming function in the app, and the robot will automatically
remove the mop assembly on the base station and start vacuuming.
Mop Only
Enable the mopping function in the app, and the robot will automatically check
if the mop assembly is installed on the base station. If not, the robot will install
the mop assembly and start mopping after the main brush and side brush are
raised.