Held eVest Clip-in Manual De Utilización página 31

User Manual | 92070 / 92170
Components
Airbag-vest
In&box
Checking the inflator's
status:
» Screw the inflator
into the In&motion
airbag system
» Plug the connector
into the inflator
» Insert the running
In&box into its
housing
Backprotector
Inflator:
gas generator
If the INFLATOR LED (light
indicator) is green,
the inflator is full.
If the INFLATOR LED (light
indicator) is red,
the inflator is empty
or not connected
EN
Airbag vest:
» Vest integrating the In&motion airbag system
In&box:
» Airbag system detection and triggering device
containing sensors and the battery (refer to the
In&box user manual provided with the In&box).
» The In&box is an electronic device placed
in the shell. It is provided with an USB cable
and its own user manual. Each In&box has a
unique identifier linked to an user account.
Before using your In&box, please carefully read
the detailed instructions in the In&motion
specific user manual dedicated to the use of
the In&box.
Inflator: gas generator
» The inflator is a gas generator. USE ONLY WITH
THE In&motion AIRBAG SYTEM.
» [Warning]: Handle with care. This generator is
filled with highly pressurized gas. Store at a
temperature below 60 °C (140 °F).
» Do not repair, do not pierce, do not refill, do not
disassemble, do not use with any other elec-
tronic equipment, users must be 18 and over to
handle the inflator. If the inflator shows signs
of damage, please send it to In&motion for
recycling. The inflator's expiry date is indicated
on the label. Do not discard a full inflator (that
has never been triggered).
Back protector:
» eVest and eVest Clip-in contain an IMP Moto
1 back protector (you will find its user manual
on page 41 ff. of this manual). An optional
replacement protector by D3O which has been
specifically designed as back protector for eVest
and eVest Clip-in can be acquired separately
refer to the manual provided with the D3O back
protector). These back protectors have been
designed specifically for two-wheeled motor
vehicle users and must be used exclusively in
association with the In&motion airbag system.
eVest Clip-in/eVest
31