Held eVest Clip-in Manual De Utilización página 42

42
eVest Clip-in/eVest
Minimum dimensions in the protection areas
Level of Protection
The protection areas of this product have been tested and certified in accordance with the
standard EN 1621-2:2014. The table below indicates the values of average residual force for
the two levels of protection defined by standard.
Explanation of the marking
Marking IMP Moto
The CE marking indicates that the impact protector is conform to regulatory requirements
EU 2016/425.
EN
Dimensions of the illustration
A B
72 % 29 %
NOTE: All dimensions are relative to the waist-shoulder length (100 %)
Dimensions of the minimum protection area on the back
protector.
Level*
1
2
*The standard refers to two levels of protection
EN 1621-2:2014
In&motion
178 Route de Cran-Gevrier
74650 Chavanod France
N°: 022018
C D
44 % 29 %
of the largest user
Average total value
≤ 18 KN
≤ 9 KN
Name of the back protector
The "CE" means that the product meets the
basic health and safety requirements of the
Regulation (EU) 2016/425
Pictogram indicating exclusive motorcycle use
of the protection with the type of FB protector
(full back protector), the performance level (1);
as well as the information concerning the size
(distance between the waist and the shoulder)
(Exemple)
Number and year of the European technical
harmonized standard: Clothing for motor
cyclists that protects against mechanical
stress - Part 2: Back protectors
Name and address of manufacturer
Product serial number (exemple)
User Manual
E F
32 % 25 %
Individual value
≤ 24 KN
≤ 12 KN