Held eVest Clip-in Manual De Utilización página 34

34
eVest Clip-in/eVest
06 Install a new inflator
» [Warning]: Do not touch the full inflator's
connector with your fingers (blue piece on the
bottom of the inflator). Do not connect the
inflator's cable before having screwed it in.
Step 01:
Screw in the new inflator
tightly.
Step 04:
Check whether the inflator is
correctly positioned, securely seated
in its slot.
EN
» [Warning]: Before carrying out the following
steps, check that the airbag system is comple-
tely void of air.
Step 02:
Plug the connector back in.
Check that it is properly connected and
plugged in fully.
Step 05:
Close the zipper to the top.
User Manual
Step 03:
Clip the inflator into its
housing.
Step 06:
To check if the inflator is
new and properly connected, insert the
activated In&box into its slot.
The inflator LED should turn green.