Held eVest Clip-in Manual De Utilización página 38

38
eVest Clip-in/eVest
Measurements of the user
without vest
If you intend to wear additional protectors under
the vest such as a chest protector harness, take
the following measurements whilst wearing them.
If not, take the following measurements without
wearing any gear but functional underwear:
» 01 Measure around your chest in cm (e.g.
100 cm)
» 02 Measure around your waist, at navel height,
in cm (e.g. 90 cm)
» 03 Add these 2 measurements, then divide by 2
(e.g. 100+90=190 and 190 / 2=95 cm)
EN
»
Measurements of your jacket or coat
» The following measurements are taken while
stretching the jacket. All the elastic fabrics and
elasticated parts in the direction of measure-
ment must be fully stretched.
» Place your closed jacket on a flat surface.
» 04 While stretching the jacket until the elasticated
parts and fabrics are taut, measure the width of
the jacket under the armpits in cm (e.g. 58 cm).
» 05 In the same way, while stretching the jacket
fully, measure the width of the jacket at navel
level in cm (e.g. 52 cm).
» 06 Add these 2 measurements (e.g.
58+52=110 cm).
Your jacket is compatible with the vest if the
difference between the first result obtained in
03 (95 cm) and the second result obtained in 06
(110 cm) is greater than or equal to 13cm. If you are
not sure, ask your local reseller for advice. Example:
110 - 95 = 15 cm -> Your jacket is compatible.
» If your jacket on your morphology is not
compatible, do not use the airbag product
with your jacket. Wearing the airbag product in
such a case may cause the airbag to function
improperly and can cause injury.
» If you need help to determine compatibility or
the correct size of the vest for you, contact
HELD customer service.
User Manual