Stiga CS 20 Li B Manual De Instrucciones página 166

Do not throw electrical equipment away
with domestic waste. According to the
European
electrical and electronic equipment waste
and its implementation, according to UK
Regulation "The waste electrical and electronic
equipment regulations 2013 (as amended)" and
according to national regulations, old electrical
equipment must be collected separately, for eco-
compatible recycling. If electrical equipment is
disposed of in landfills or in the ground, hazardous
substances can leak into the groundwater and
contaminate the food chain, damaging your health
and well-being. For further information on the
disposal of this product, contact your dealer or a
domestic waste collection service.
At the end of their working life, dispose of
batteries paying due attention to the
environment. Batteries contain material
classified as hazardous for you and the
environment. They must be removed and
disposed of separately at a facility that accepts
lithium-ion batteries.
Separate waste collection of the products
and packaging used allows the materials
to be recycled and reused. Reuse of
recycled materials
environmental pollution and reduces the
demand for raw materials.
3. GETTING TO KNOW THE MACHINE
ATTENTION
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
To be accurate, an estimation of exposure level
in the actual conditions of use should also take
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle but not actually doing the job. This
may significantly reduce the exposure level over
the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
Directive 2012/19/EU
help to
3.1 DESCRIPTION OF THE MACHINE
AND PLANNED USE
on
The machine is essentially composed of a
batteries powered motor and a guide bar that
that takes the power from the battery to the motor
which drives the cutting chain.
The operator is able to operate the machine with
two hands, using the front and rear hand grips,
and can use the main controls, always remaining
at a safe distance from the cutting means.
3.1.1 Intended use
This machine was designed and manufactured
for:
– trimming and cutting of tall tree tops;
– cutting hedges, trunks or wooden beams, the
diameter of which depends on the length of
the guide bar;
– cutting wood only;
– use by one operator only;
3.1.2 Improper use
Any other usage not in keeping with the above-
mentioned ones may be hazardous and harm
prevent
persons and/or damage things. Examples of
improper use may include, but are not limited to:
– trimming hedges;
– carving operations;
– sectioning pallets, crates and various packing
materials;
– sectioning furniture or other materials with
nails, screws or other metal components;
– butchering meat;
– using the machine to cut materials other than
wood (plastic materials, building materials);
– using the machine to lift, move or split objects;
– using the machine while fastened to fixed
supports;
– using cutting means other than those found in
the "Technical Data" table; Serious injury and
wound hazard;
– use of the machine by more than one person.
IMPORTANT Improper use of the machine will
invalidate the warranty, relieve the Manufacturer
from all liability, and the user will consequently be
liable for all and any damage or injury to himself
or others.
3.1.3 User types
This machine is intended for use only by operators
trained in forest maintenance.
EN - 6