Stiga CS 20 Li B Manual De Instrucciones página 173

6. check there are no loose or damaged
components. If
damaged components and tighten any screws
and loose bolts.
IMPORTANT Always remove the batteries
and fit the blade guard whenever the machine is
unused or left unattended.
6.7.1 Removing the batteries
To remove the batteries press the lock button on
the battery (Fig. 30. C).
7. ROUTINE MAINTENANCE
7.1 GENERAL INFORMATION
The safety regulations to follow are
described in chap. 2. Strictly comply with
these instructions to avoid serious risks or
dangers.
Before conducting
cleaning or
interventions on the machine:
• Stop the machine and turn off the motor;
• Wait until the chain is stationary;
• Remove the battery from its housing;
• Apply the bar cover, except when working
directly on the chain or bar itself.
• Wait until the motor is sufficiently cold;
• Read the relevant instructions;
• Use suitable clothing, protective gloves and
goggles;
• The frequency and types of maintenance are
summarised in the "Maintenance Table". This
table will help you maintain your machine's
safety and performance.
the main interventions to be made and the
frequency applicable to each of them. Carry out
the relevant intervention according to the first
deadline.
• The use of non-genuine and/or incorrectly
assembled spare parts and attachments could
adversely affect machine operation and safety.
The manufacturer shall decline all liability in the
event of injuries or damages caused by such
parts.
• Genuine spare parts are supplied by authorised
assistance workshops and dealers.
IMPORTANT Any
adjustment operations not described in this
manual must be carried out by your dealer or
Authorised Service Centre.
necessary, replace
any inspections,
maintenance/adjustment
It summarises
maintenance
7.2 TOPPING UP THE CHAIN OIL TANK
the
NOTE The following symbol is found
near the chain oil tank cap (fig. 31.A):
IMPORTANT Only use chainsaw oil or
adhesive oil for chainsaws. Do not use oil
containing impurities so as not to block the oil filter
and to prevent irreparable damage to the oil pump.
It is essential that you use good quality oil to
lubricate the cutting parts effectively. Used or poor
quality oil does not guarantee good lubrication
and reduces the working life of the chain and bar.
IMPORTANT Never run the chain without
sufficient oil, this could damage the saw and
compromise safety.
Check the amount of oil in the chainsaw by
checking the oil level indicator (Fig. 31.B).
If the oil level is low, top up as follows:
1. Unscrew and remove the cap (Fig. 31.A) from
the oil tank.
2. Pour oil in the tank and monitor the level on the
indicator (Fig. 31.B).
3. Make sure no impurities penetrate the oil tank
when filling.
4. Screw on the oil cap and tighten it.
7.3 CHAIN CATCHER
Check the chain stop pin conditions before each
use (Fig. 1.G) and repair in the event of damages.
7.4 MACHINE AND BAR LUBRICATION
HOLES
Before daily use, remove the guard (Fig. 5. B),
disassemble the bar and check that machine
lubrication holes (Fig. 32.A) and guide bar (Fig.
32.B) are not clogged.
7.5 NUTS AND BOLTS
• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
• Check regularly that the handles are fixed firmly.
and
EN - 13
Chain oil tank