HoMedics BPM83 Manual Del Usuario página 5

BATTERY INSTALLATION
Low battery warning:
It is necessary to replace the batteries when the Low Battery symbol "
display does not turn on after the POWER key is pressed.
Replacing the Battery:
1. Press down on latch and lift the cover on the bottom of the monitor.
2. Insert or replace 4x 1.5 V AAA batteries into the battery compartment, ensuring to match the indicated polarity
symbols. Always use new batteries.
3. Replace the battery cover.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to
the instructions.
NOTE: Battery-operated
1. Please properly dispose of the batteries away from small children and heat. Do not let children swallow the
battery.
2. Remove the batteries if the unit will not be used for more than 1 month.
3. Batteries must be disposed of in accordance with local environmental and institutional policies.
SETTING THE DATE AND TIME
It is necessary to set the date and time for the unit every time batteries are initially installed or replaced.
To set the date and time, proceed as follows:
• While in power off mode, press and hold the "SET" key for at least 3 seconds to enter Date and Time setting
procedure and the Year value will begin to flash.
• Press the "SET" key to advance the display to the desired year, press the "M" key to confirm the year.
• Next, the month will blink. Repeat step 2 to set the month and date, then hours, then minutes.
• After setting the minutes, the unit will automatically exit out of the date/time setting mode and shut off.
Load
Batteries
Year
Press SET Key
M KEY
Hour
M KEY
Month Year
Press SET Key
M KEY
Minute
Press SET Key
5 I EN
" appears on the display, or when the
M KEY
Day
Press SET Key
M KEY
Press SET Key