Publicidad
Idiomas disponibles
Idiomas disponibles
_MSK.book Seite 25 Montag, 26. Februar 2007 10:15 10
SinePower
Use the device only as intended.
Do not operate the device in a damp or wet environment.
Do not operate the device near any flammable materials.
Do not operate the device in areas prone to explosions.
Maintenance and repair work may only be carried out by qualified person-
nel who are familiar with the risks involved and the relevant regulations.
2.2
Safety when installing the device
Ensure that the device has a firm foundation.
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
Take the precautions necessary to ensure that children cannot interfere
with operation.
Dangerous situations may occur which cannot be recognised by
children!
Do not expose the device to a heat source (such as direct sunlight or heat-
ing). Avoid additional heating of the device in this way.
For installation on boats
If electrical devices are incorrectly installed on boats, corrosion damage
might occur. Have the inverter installed by a specialist (marine) electri-
cian.
Electrical cables
If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or tubes to prevent damage.
Do not lay cables which are loose or bent next to electrically conductive
material (metal).
Do not pull on the cables.
Do not lay the 230 V mains cable and the 12/24 V DC cable in the same
duct.
Fasten the cables well.
Lay the cables so that they cannot be tripped over or damaged.
General safety instructions
25
Publicidad
