Waeco SinePower SP700 Instrucciones De Uso página 33

_MSK.book Seite 33 Montag, 26. Februar 2007 10:15 10
SinePower
8.3 Permanently connecting the 230 V output cable
The permanent connection of the 230 V output cable may only be
performed by an electrician.
On the MSK2000 and MSK3000 a 230 V output cable can be permanently
connected.
Danger of electrocution
Before connecting the 230 V output cable, make sure the inverter
is switched off at the main switch.
➤ Set the main switch (6 2, page 4) to "Off".
➤ Open the front plate.
➤ Connect the 230 V output cable to the terminals behind it.
➤ Close the front plate again.
➤ Fasten the 230 V output cable with the strain relief on the front of the
device.
9 Using the inverter
9.1 Switching on the inverter
➤ Set the main switch (6 2, page 4) on the front of the inverter to the "ON"
position.
✓ The inverter performs a self-test.
During the self-test, the built-in speaker emits tones and the LEDs flash in
various colours.
✓ After the self-test the "Input Level" (6 3, page 4) and "Status" (6 5, page 4)
LEDs light up green.
Using the inverter
33